Средства разработки интерфейсов UMFT230XB-01

Коммутационный модуль USB - UART , обнаружение зарядного устройства батареи USB, 300бод до 3Мбод

UMFT230XB-01 breakout module utilizes FT230XQ IC to convert USB to basic UART module. UMFT230XB bridges from USB to UART IC. This hardware is a low cost breakout board form factor that converts USB2.0 full speed to a serial interface and connects the serial signals to a 2.54mm (0.1inch) pitch 10pin female receptacle. The boards do not use a USB connector, but instead the modules plug directly into the USB host connector and the pads of the PCB makes electrical contact with the electrical contacts of the USB connector.

• Single chip USB to asynchronous serial data transfer interface
• Entire USB protocol handled on the chip. No USB specific firmware programming required
• Royalty free VCP and D2XX drivers eliminate the requirement for USB driver development in most cases
• Configurable CBUS I/O pin
• Device supplied preprogrammed with unique USB serial number
• Supports bus powered, self powered and high power bus powered USB configurations
• Integrated power on reset circuit
• Low USB bandwidth consumption
• UHCI/OHCI/EHCI host controller compatible
• USB 2.0 full speed compatible

Области применения

Связь и Сеть, Беспроводное, Аудио, Визуализация, Видео и Зрение, Промышленное, Считывание и Контрольно-измерительная Аппаратура, Потребительская Электроника