Средства разработки интегральных схем (ИС) преобразования данных 410-063

Периферийный модуль , ЦАП, PmodDA1, 8-битный, 4 канала, AD7303

Средства разработки интегральных схем (ИС) преобразования данных Pmod-DA1 - Four 8-bit D/A outputs

The 210-063 is a PmodAD1 digital to analog module converter board(DA1). The DA1 is equipped with two AD7303 digital to analog converter. Each converter has two channels through which digital signals can be converted to analog signals. It converts signals from digital to analog at up to one MSa per second. The DA1 uses a 6 pin header connector and at less than one square inch is small enough to be located where the reconstructed signal is needed. The DA1 can produce an analog output ranging from 0V to 3.3V. It has four simultaneous D to A conversion channels, each with an 8bit converter that can process separate digital signals. Outputs are produced by sending commands via the SPI/MICROWIRE serial bus to the D to A converter. The two converters are connected in parallel so that commands are sent to both converters simultaneously. The DA1 is designed to work with Diligent system boards. Some system boards, like Pegasus board.

• Very low power consumption
• Small form factor (0.80inch x 0.80inch)

Области применения

Связь и Сеть The DA1 can be powered by voltage from either a Diligent system board or an outside device. Damage can result if power is supplied from both sources or if the outside device supplies more than 3V.